Figure 38. Removing the side wall bracket
Next steps
1.
Installing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
on page 47.
3. If installed,
4.
.
5. If installed,
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the side wall bracket with the tabs on the chassis.
2. Press the side wall bracket with your thumbs until the bracket firmly clicks into place.
NOTE:
Route the cables through the side wall bracket.
3. Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
68
Installing and removing system components
Содержание PowerEdge R7525
Страница 25: ...Figure 14 Service information System overview 25 ...
Страница 79: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 79 ...
Страница 80: ...Figure 55 16 x 2 5 inch Figure 56 24 x 2 5 inch with NVMe 80 Installing and removing system components ...