Installing the internal USB card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card risers
.
Steps
1. Connect the USB key to the internal USB card.
NOTE:
Ensure to install the internal USB card in the IDSDM/USB card slot and not in the J_R3_PCIE_PWR
connector slot.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 116. Installing the internal USB card
Next steps
1.
Install the expansion card risers
2. Follow the procedure listed in
After working inside your system
3. While booting, press F2 to enter
System Setup
and verify that the system detects the USB memory key.
Intrusion switch module
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
on page 47.
3.
Remove the expansion card riser
.
156
Installing and removing system components
Содержание PowerEdge R7525
Страница 25: ...Figure 14 Service information System overview 25 ...
Страница 79: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 79 ...
Страница 80: ...Figure 55 16 x 2 5 inch Figure 56 24 x 2 5 inch with NVMe 80 Installing and removing system components ...