Figure 90. Removing the accelerator card from riser 1B
4. Install a filler bracket if you are not replacing the expansion card. For information about how to install a filler bracket, see installing a
topic.
Next steps
1.
.
Installing an accelerator card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
on page 44.
3. If installing a new expansion card, unpack it and prepare the card for installation.
NOTE:
For instructions, see the documentation accompanying the card.
4.
.
Steps
1. Pull and lift to open the expansion card retention latch lock.
2. If installed, remove the filler bracket. For information about how to remove filler bracket, see the removing a filler bracket section in
the
3. Hold the card by the edges, align with the connector on the expansion card riser and press until the card is seated in place.
Installing and removing system components
105
