Dell EMC 6WDJR, Инструкция по установке и обслуживанию

Страница: 87 / 129

Figure 61. 2.5-inch (x8) SAS/SATA/SSD backplane
1 Release tabs (2) 2 Backplane SAS B0 connector
3 Backplane signal connector 4 Backplane SAS A0 connector
5 Backplane Power A connector
Figure 62. 3.5-inch (x4) SAS/SATA backplane
1 Release tab (2) 2 Backplane SAS A0 connector
3 Backplane Power A connector 4 Backplane signal connector
Removing the drive backplane
Prerequisites
CAUTION: To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION: Note the number of each drive and temporarily label them before removal so that you can replace them in the same
drive slots.
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the drives .
4 Disconnect the following cables from the backplane:
a
Backplane signal cable
b Backplane power cable
c PERC cable
NOTE: Observe the routing of the cable as you remove it from the system.
Steps
1 Press the blue release tabs to disengage the drive backplane from the hooks on the chassis.
2 Lift the drive backplane out of the system.
NOTE: To avoid damaging the backplane, ensure that you move the control panel cables from the cable routing clips before
removing the backplane.
Installing and removing system components 87