Dell EMC 6WDJR, Инструкция по установке и обслуживанию

Страница: 72 / 129

Steps
1 Connect the PERC cable to the PERC card.
2 Flip and insert the PERC card in the connector on the system board.
3 Press the tab on the blue release latch to disengage it from the slot on the chassis.
4 Rotate the blue release latch until it locks with the PERC card.
5 Secure the blue release latch with a screw.
Figure 46. Installing the PERC card
Next steps
1 Install the expansion card riser .
2 Follow the procedure listed in the After working inside your system .
System battery
Replacing the system battery
Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
See the
Safety instructions . that came with your system for more information.
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
Steps
1 Push the battery holder clip away from the battery.
CAUTION: To avoid damage to the battery holder clip, ensure that you do not bend the battery holder clip while installing or
removing a battery.
2 Pull the battery out of the battery holder.
NOTE: Ensure that the + side of the battery is facing the battery holder clip.
72 Installing and removing system components