Delfield Specification Line GA Series, Оригинальное руководство по обслуживанию

Страница: 12 / 104

12 Part Number GA_SM 08/18
Installation Section 2
Level & Stable
After the cabinet has been placed in the desired location,
cabinets must be leveled. Level units from front to back and
from side to side. Leveling will insure proper door operation
and removal of condensate.
• It is very important that all legs are properly adjusted to
keep the cabinet level, evenly distribute the weight and
to make sure the unit will not rock, lean or be unstable.
• Cabinets with casters must have the caster brake set so
the cabinet cannot move. Shim casters if necessary to
level unit.
• Roll-In and roll-thru units must also be level. Shim the
bottom of the unit if necessary. See Roll-In & Roll-Thru
Installation on page 13.
• Adjust doors and hinges until doors close properly.
Shelf Installation
1. Insert the clips into the pilaster holes at the desired shelf
heights.
2. Set the shelves on the clips.
Reversible Door Instructions
APPLICABLE TO FULL DOOR MODELS
1. Open the door.
2. Remove two bolts securing the hinge bracket above the
door.
3. Lift the door up and out.
4. Save the hinge bracket.
5. Remove three bolts securing the hinge bracket to the
bottom of the unit.
6. Flip it over and install it on the opposite side.
7. Rotate the door 180°.
8. Move the white nylon washer from the top hinge pin to
the bottom hinge pin.
9. Insert the bottom hinge pin into the hinge bracket.