-11-
142766 - PRO-TILL 10|13 (10-February-2022)
Troubleshooting - Pro-Till 10/13
Leaving a groove between passes:
- Adjust deflector down to fill groove.
- Adjust deflector assembly in to fill groove.
- Check that end disc size configuration matches factory
suggested setup.
- Reduce implement width on guidance system for
slightly more overlap.
Subsoil leaving a groove every 10”:
- Adjust pitch to level machine. (
Disc rows are not set to
the same depth.
)
- Adjust pitch to lower rear disc row by extending
3-point top link. (
Front is prone to running deeper
with floating hitch & firm soil conditions.
)
- Rear discs following in front disc groove. (
Refer to the
troubleshooting note for this below.
)
Hopping or leaving waves:
- Change operating speed. (
Best performance is
achieved over 10mph.
)
- Change field working angle. (
Best finishing at 5 to 20
degrees off previously worked.
)
- Adjust working depth. (
Either deeper & run slower or
shallower to run faster.
)
- Pre-work heavy trash or wet areas at a slower speed
& at a different angle than final pass.
- Wait for soil conditions to dry out more.
- Ensure tractor has correct tire pressure and is properly
ballasted.
Rear discs following in front disc cut or discs
not doing a full cut:
- Adjust tracking by extending the top 3-point link to
track right or retracting the top link to track left.
- Adjust entire front row in small increments either left
or right to achieve full cut. (
Start by moving front row
to the left in small increments.
)
- Check disc wear & adjust gang spacing or replace
discs as necessary. (
As discs wear, move front row
right.
)
- Check factory settings on disc row locations to verify
gang clamp hardware is tight & clamps have not slipped.
- Adjust GPS to actual cutting width
(see chart)
minus 4”
overlap per side depending on working depth.
(with 20" discs)
2" Depth
MAX Depth
Pro-Till 10
117” (2.98m)
119” (3.02m)
Pro-Till 13
157” (3.99m)
159” (4.04m)
- Adjust working angle to approximately
20 degrees to the right from previously
worked or seeded rows.
(Recommended practice)
Содержание PRO-TILL 10
Страница 2: ......
Страница 24: ... 18 142766 PRO TILL 10 13 10 February 2022 ...
