Degelman PRO-TILL 10, Руководство оператора и каталог запасных частей

Страница: 16 / 35

-10- 142766 - PRO-TILL 10|13 (10-February-2022)
Troubleshooting - Pro-Till 10/13
Restriction or blocking on right side:
- Raise the deflector plate.
- Move deflector assembly outward.
- Raise machine working depth.
- Reduce operating speed slightly.
- Check condition & operation of disc hubs. (
Make sure
they turn freely. )
- Wait for soil conditions to dry out more.
Rear discs or roller not engaging in very
hard soil:
- Adjust pitch so front discs are higher by extending
3-point top link. ( It may be necessary to also lower
the overall machine depth. )
- If your trator is equipped with 3-point downforce
capability, try applying downward pressure.
Mud not clearing from rubber roller:
- Check scraper to roller distance & adjust if necessary.
( Scraper should be 1/4" to 3/8” from roller. )
- Check scraper plate wear & adjust or replace as
necessary. ( Replace all scrapers per row at the same time. )
- Check scraper row adjustment for slippage &
re-torque or replace hardware if necessary.
Roller plugged in wet conditions:
- Lift 3-point to pass over pushed up mound & smooth
out when soil dries.
- Fully extend depth cylinder & drive 12-14 mph on firm
soil to clear rollers.
- In certain wet soil conditions place scrapers in storage
position to continue operating.
- If plugging persists wait for soil conditions to dry out
even more.
Roller skidding in wet conditions:
- Check scraper operation & settings.
- Raise machine working depth.
- Adjust pitch so front discs are slightly lower by
retracting 3-point top link & add depth stops to raise
machine working depth.
- Wait for soil conditions to dry out more.
- Check condition & operation of bearings on both ends
of the roller.
Plugging disc rows in wet conditions:
- Ensure roller is turning & scrapers are set properly.
- Raise machine working depth.
- Increase operating speed slightly.
- Adjust pitch so front discs are slightly higher by
extending 3-point top link.
- Check condition & operation of disc hubs. ( Make sure
they turn freely. )
- Wait for soil conditions to dry out more.
Leaving a ridge between passes:
- Adjust deflector up to reduce ridge.
- Adjust deflector assembly out to reduce ridge.
- Check that end disc size configuration matches factory
suggested setup.
- Adjust implement width on guidance system for
slightly more or less overlap.