Degelman PRO-TILL 10, Руководство оператора и каталог запасных частей

Страница: 13 / 35

-7-
142766 - PRO-TILL 10|13 (10-February-2022)
Operation
1. Cycle oil in the Depth Control Cylinder (#1) before
use. This is especially important after long periods
of storage.
2. Lower tractor 3-point arms.
3.
IDEAL OPERATING SPEED is 10-12 mph.
Minimum operating speed is 8 mph.
Maximum operating speed is 14 mph.
4. Raise the machine out of the ground using the
3-point linkage when making headland turns.
5. Run the machine with the discs in the ground at
desired depth for a short distance. If the machine
is pitched forward or backward, adjust the 3-point
hitch top link, or raise the roller and add/remove
depth stops. Repeat until the machine is level at
desired working depth.
Note: It is recommended to start with the Pro-Till
adjusted so the front discs are 1/2" to 3/4" higher
than the rear discs (Use top link to adjust).
6. Each time you start a new field you may need to
adjust the cutting depth depending on the type of
crop residue or soil conditions. The operator can
adjust the cutting depth by following the guidelines
in the “Setting Disc Depth” section.
7. After making adjustments to the cutting depth it is
recommended to bring the Pro-Till up to speed (10-
12mph) to test the depth setting by driving about
100m (cutting performance changes dramatically
from a slow speed to high speed). Stop, check depth
and cut of field, re-adjust the height higher or lower,
if needed, based on your preference.
Remember: Removing one depth stop lowers cutting
depth 1/2” deeper, Adding one depth stop raises
discs up 1/2” higher.
8. Check/adjust the deflector shield height setting.
9. Harder, packed soil may require additional passes
for optimum results. It is recommended to do a
second pass at an angle to the original pass.
OPERATING GUIDELINES FACTORY DISK SETUP
20" Outer Disc
RH Front
20" Discs at all
other locations
20" Outer Disc
LH Rear
Outer Disc - RH Rear: 18"
22" Outer Disc
RH Front
22" Discs at all
other locations
22" Outer Disc
LH Rear
Outer Disc - RH Rear: 20"
20" Disc Setup
22" Disc Setup