Degelman PRO-TILL 10, Руководство оператора и каталог запасных частей

Страница: 14 / 35

-8-
142766 - PRO-TILL 10|13 (10-February-2022)
NOTE: As the discs wear with usage, the disc depth
settings will also need to be adjusted accordingly.
Use the following as a guideline for setting depth:
1. Drive the PRO-TILL onto level ground. For initial
setup, try "14 Depth Stops" on depth cylinder.
2. Fully retract the Depth (#1) cylinders to lower
rear frame to ground.
3. Check the penetration depth of the front and
rear row of discs. Take note of how much you
would like to raise or lower both the front and
rear disc sections - round to the nearest 1/2”.
4. Fully raise the frame back off the ground by
extending the Depth (#1) cylinders.
5. Adjust Disc height.
Lower Discs - Remove one Depth Stop for each 1/2”
Raise Discs - Add one Depth Stop for each 1/2”
6. Repeat above procedure until proper depth is
achieved.
7. Adjust Dirt Deflector height as shown below.
SETTING DISC DEPTH & DIRT DEFLECTOR
Operation
RECOMMENDED PROCEDURE TO SET DEFLECTOR HEIGHT:
1 - Run the machine with discs set to the proper depth.
2 - Stop the machine.
3 - Adjust the height so the deflector is running just
slightly above the ground.
Typically
Set to 2”
Dirt Deflector
PITCH ADJUSTMENT
Some operators may also prefer to adjust the
front or rear frame disc sections to run slightly
higher than the other. Adjustments to the front
to rear disc section height or "pitch" are done
with the top link of the 3-point hitch:
• Lengthening 3-point top link:
- Lowers the Rear Discs
- Increases Roller Pressure
• Shortening 3-point top link:
- Raises the Rear Discs
- Decreases Roller Pressure
NOTE: For better performance, adjust pitch
slightly higher on the front (lengthen top link)
to increase roller pressure.
DEPTH SETTING OVERVIEW
Adjusting the disc cutting depth is accomplished by
adding or removing a number of spacers from depth
adjustment cylinder.
The spacers limit the stroke distance of the cylinder,
changing the amount that the disc frames are lowered.
Each spacer that is added to the cylinders raises the
frame height by 1/2”. Therefore, to lower discs deeper
into the soil, you would remove one spacer for each
1/2” of depth change required.
A typical recommended penetration depth of 2” is
suggested. This depth, however, can be adjusted to the
operators needs and preferences or based on different
crop varieties and soil conditions.
(Start with14 stops
per cylinder, test
depth & adjust)
(IMPORTANT: Add depth
stops starting from depth plate end )
Disc Depth
Adjustment
Adjust "Dirt Deflector Angle" whenever
the Pitch of the Frame is adjusted.
Note: If running Nose up or Nose down ,
adjust the deflector angle accordingly.
IMPORTANT: You may need to adjust the
deflector height according to soil penetration.
Best setting is when deflector runs just slightly
above the ground.