Defro Home VITAL 37S, Руководство по эксплуатации

Страница: 33 / 52

33
9. MAINTENANCE AND SERVICE
To ensure correct operation of the equipment and that it does not
pose any threats it should be cleaned on an ongoing basis and undergo
inspections and maintenance by the authorized company or service.
Periodic inspection of the equipment should be carried
out only by qualified manufacturer’s service.
The user should check and clean:
combustion chamber,
window panel,
decorative items - chunks, stones,
outlet duct.
All maintenance operations should be performed only when the
equipment is switched off, does not operate and it is cooled down to
room temperature.
All maintenance operations can be performed only
when the gas supply is cut off, the heater is switched
off and is at room temperature.
9.1. WINDOW PANEL CLEANING
Majority of dirt can be removed with dry cloth. You may also use
liquid for cleaning of ceramic tiles. Do not touch the window panel with
your fingers during cleaning because the fingerprints on the window
panel harden as a result of temperature and they cannot be removed!
Do not touch the window panel with your fingers; if you
leave fingerprints, they may be removed with a cloth.
Do not use abrasive materials and chemicals, not
intended for this purpose, for cleaning of window panel.
Their use may damage the window panel, for which the
manufacturer shall not be liable.
While cleaning the window panels using chemical agents
intended for this purpose, they should not be used on
other surfaces or components (e.g. painted) because
they may damage them.
9.2. WINDOW PANEL DISMANTLING
To clean the window panel, combustion chamber or install
decorative items, it is required to remove the window panel(s). Below
you will find the removal instruction for window panels based on the
example of corner version of fireplace (with two window panels). In the
version with one window panel, the arrangement of strips is the same
as for the front window panel with an additional, second side strip. For
a version with three window panels: the second side window panel
should be installed in the same way as given below.
1. Remove all end caps of the base located around the
window panel.
2. In a model with three window panels: remove the front
window first, which is pressed from top by a hinged beam.
Pull it back and then shift the lock in direction given on the
picture to lock the beam in position, allowing removal of
the window panel. In a fireplace with one or two window
panels, you should first remove the side masking frames of
the front window panel. Description of side masking frames
removal is given in item 4.
3. The front window panel should be lifted first so as to its
bottom edge leaves the base and then the bottom part of
the window panel should be deflected outwards. In such
position, the window panel can be removed from the upper
block and out of the fireplace.
4. Remove side masking frames, which are equipped with
magnets. First catch the handle and pull the bottom part
back and then pull the upper part of the masking frame.