DEFA BG600, Руководство пользователя

Страница: 10 / 20

Boat
GB
NB! All communiction with the alarm is by SMS. When an alarm is triggered, an SMS message
is sent to a pre-selected mobile number. A maximum of 3 different mobile numbers can receive
messages at the same time.
It is also possible to activate/deactivate the alarm using SMS, as well as checking the status of
the alarm and receiving an answer by SMS:
Is the alarm activated or deactivated? Are the sensors connected or disconnected? What is the
temperature on board the boat? What is the boat’s battery voltage? What is the boat’s position,
where in the world is it (requires GPS)?
It is possible to activate a maximum of four control outputs by
SMS (depending on how the alarm is installed). E.g. to turn on
the boat’s heaters.
NB! In order to be able to communicate with the alarm by SMS,
you must install an SMS card in the alarm. If you use a top-up
card in the alarm, you must remember that certain telephone
providers require the card to be topped up at least once per
year. As the SMS function will not work with an empty card, the
balance on the card must be regularly checked.
NB! When the SIM card has been acquired, the PIN control must
be turned off before the card is installed in the alarm central unit.
You do this by fi rst installing the SIM card in a mobile phone,
then selecting PIN control OFF. The method depends on the
telephone being used. You will fi nd the method in the user guide
for the mobile phone.
Security code (PIN code 3):
All commands begin with this code, so that unauthorised persons
cannot gain access to your boat via SMS. The default code
from the factory is four zeroes (0000). Remember to change
this code as quickly as possible after installation of the alarm
(see changing the security code). The PIN code must contain 4
characters, fi gures and/or letters.
Important! Read the chapter about PIN codes before you change this code.
NB! The alarm is caps sensitive. If you have changed your PIN code from 0000 to e.g. CODE,
you must enter KCDE as the PIN code in your commands. If you enter the PIN code with lower
case letters it will not work.
60
�
� � � � �
� � � � �
� � � � �
� � � � �
� � � � �
� � � � � �
� � � � �
� � � � � �
�
�
10 GSM PHONE