64
WHAT YOU SEE
WHAT TO DO
➡
Igniting of the burners:
No sparks are produced when the keys are pressed
✓
Check the electrical connecting of the hob
✓
Check that the electrodes are clean
✓
Check that the burners are clean and correctly assembled
➡
When a burner is ignited, sparks are produced at all the
burners
✓
This is normal. The ignition function is centralised and controls all the burners at the same time.
➡
Sparks are produced, but the burners do not ignite.
✓
Check that the gas inlet is not trapped
✓
Check that the inlet length is less than 2 metres.
✓
Check the gas inlet opening.
✓
If the gas is coming from a cylinder or tank, check that it isn't empty
✓
If you have just installed the hob or changed the gas cylinder, repeat the ignition process seve-
ral times until the gas reaches the burners.
✓
Check that the injector is not blocked, and if this is the case, unblock it using a safety pin.
✓
Ignite your burner before placing your pan on it.
➡
When in reduced mode, the burner goes out or the
flames remain large
✓
Avoid strong currents or air in the room.
✓
Check the correspondence between the gas used and the injectors installed (see the marking of
the injectors in the section
"gas properties"
).
✓
Reminder : the hobs are originally set for network gas (natural gas).
✓
Check that the gas supply changing switch is correctly positioned (see the
"Changing the gas
supply"
paragraph).
➡
The flames have an irregular appearance.
✓
Check the cleanness of the burners and of the injectors underneath the burners, check that the
burners are correctly assembled, etc…
✓
Check that there is enough gas in your cylinder.
Using your hob in all simplicity
