Deagostini Model Space HUMMER H1, Инструкция по сборке

Страница: 26 / 28

HUMMER H1: STEP BY STEP
™
192
16 16
20 20 18 18
22 22
19 19
17 17
21 21
Place the second 3 ×
10mm binding-head screw
into the adjacent hole,
then tighten both fully.
Turn the chassis around and place the
second 3mm nut into the next groove in the
roll bar. Tighten the screw into the nut with a
screwdriver. Be careful not to overscrew, as
this can damage the inside of the nut. Holding the nut in place with your finger,
turn the chassis around and place a 3
× 12mm countersunk screw into the
corresponding hole on the underside of the
roll bar.
Tighten both screws
fully.
Next, inspect the longer
arm of the roll bar – it does
not matter if it has come
away from the chassis
surface a little. Place a
3mm nut into the groove
in the tip of the arm, as
shown by the arrow.
As you did with the
first screw, turn around
and place the screw
into the second hole.
Assembled parts