Deagostini Model Space HUMMER H1, Инструкция по сборке

Страница: 13 / 28

HUMMER H1: STEP BY STEP
™
179
11
55
33
77
22
66
44
88
Place the center gear
mount front flat on your
work surface, as shown. The
center gear mount front and
back parts look very similar,
so make absolutely sure
you select the front part.
Place one of the 3 × 12mm
binding-head screws into
the first hole, as shown.
Insert the tip of the main
gear shaft into the hole
in the underside of the
center gear mount back,
following the arrow.
Repeat Steps 1 and 2 for
the other hole, so that both
holes are left with the screw's
indentations, forming the
'tapped' inside (see circles).
Making sure not to dislodge
the main gear, place the
center gear assembly into
the second hole on the
underside of the gear mount,
as shown.
Turn the screw with a
screwdriver, making sure the
screw enters the gear mount
perfectly straight. When you
feel the screw reach the far
side of the mount, carefully
remove the screw, again
making sure to keep the
screw straight.
Remove the masking tape
from the main gear assembly
built in Stage 38.
Adjust until the teeth of the
center gear engage fully
with those of the main gear
(circled). Make sure not to
force the parts, as this may
damage the teeth. Once
engaged, ensure the center
gear is sitting straight.
Next, re-familiarize yourself
with the proportions of the
center gear assembly built in
Stage 37. The left side is thicker
and the right side is thinner.