Deagostini Model Space HUMMER H1, Инструкция по сборке

Страница: 24 / 28

HUMMER H1: STEP BY STEP
™
190
11
44
22
66
55
33
77
Lay the main chassis assembly (Stage 40)
on your work surface facing to the left.
Place the center gear mount (also Stage 40)
in the center, as shown here. Next, lay out
both driveshafts – the longer of the two is
the rear driveshaft, and the shorter is the
front driveshaft. The difference in length
is not large, so make sure not to get these
confused.
Holding the driveshaft
carefully so that the end
fitted in Step 2 doesn't fall
out of the cup joint, angle
the center gear mount so
that its protruding cup joint
accommodates the other
end of the driveshaft.
Place one end of the
front driveshaft into the
differential cup joint facing
out of the front bulkhead
(circled).
Making sure neither end
of the front driveshaft is
dislodged, fit the tip of the
rear driveshaft into the
second cup joint.
Make sure the metal pin set
into the end of the driveshaft
fits into the two slots in the
cup joint.
Again, make sure the tip
of the driveshaft is fully
inserted into the cup joint.
Holding the parts together
carefully, fit the other end of
the rear driveshaft into the
differential cup joint beneath
the rear bulkhead.
(Shorter)
Front driveshaft Rear driveshaft
Front
Back
(Longer)