Deagostini Model Space HUMMER H1, Инструкция по сборке

Страница: 14 / 28

HUMMER H1: STEP BY STEP
™
180
99
13 13
11 11
15 15
12 12
16 16
10 10
14 14
Press the parts firmly
together.
Place the 3 × 3mm set
screw onto the tip of the
Allen key, and apply a little
thread-locking agent (or
rubber-based adhesive).
It is very important that
the parts fit together
snugly, so check closely
against the photo to
make sure that your
assembly looks exactly
like this.
Position the gear mount
assembly on your work
surface, as shown, then
carefully place the brake
cam into the arrowed slot,
with the short side of the
cam facing you.
Press the parts firmly
together, making sure
that the ball bearing on
the center gear shaft sits
inside the hole of the gear
mount front, as shown.
Inspect the cam section of
the brake cam (pictured) –
there is one short side and
one long side.
Place the center gear
mount front part over the
tips of each gear assembly
and press together,
following the arrows.
Check against the photo
that you have the parts
aligned correctly.
Hold the brake cam level,
as shown, and carefully
insert the set screw. Make
sure that the set screw is
in perfectly straight, then
tighten by two rotations.