DDK HFC3000II, Инструкция по эксплуатации

Страница: 81 / 216

Chapter 6 Description of Operations
PAGE 6-13
●
List of Contents Indicated in the Fastening Result Mode(2/2)
WORK
COUNT
/D-NO
DATA Judgment Unit
r01
～
r64
21 Rate 1 increment torque (torque from start of rate 1 to end of rate 1) N
•m
22 Rate 1 increment angle (angle from start of rate 1 to end of rate 1) Deg
23 Rate 2 increment torque (torque from start of rate 2 to end of rate 2) N
•m
24 Rate 2 increment angle (angle from start of rate 2 to end of rate 2) Deg
25 Rate 3 increment torque (torque from start of rate 3 to end of rate 3) N
•m
26 Rate 3 increment angle (angle from start of rate 3 to end of rate 3) Deg
27 Peak current (current high/low limit warning indication)
H/L
A
28 Rundown revolutions
H/L
rev.
29 Load rate %
30 Current value at stopping of fastening
A
31 ------ indication
32
Spindle cycle count (×1 million)
* “--" if less than 1 million cycles
33 Spindle cycle count (×1)
34 Tool cycle count (×1 million)
* “--" if less than 1 million cycles
35 Tool cycle count (×1)
36
ACCEPT COUNT *0 to cycle count (0 to 99)
This DATA indication is always performed as [c##] for COUNT/D-No.
00.
37
Peak torque (upper part)
Final angle (lower part)
S0140185-H