DDK HFC3000II, Инструкция по эксплуатации

Страница: 109 / 216

Chapter 6 Description of Operations
PAGE 6-41
(Continued from previous page)
Item D-No. Contents
Setting
change
Units
Connected
Tool Settings
100 Connected Tool No.
101
Connected Tool Information “015-P1”
102 Connected Tool CAL Torque Decimal Point Position
103 Connected Tool CAL Torque Nm
104 Connected Tool CAL Voltage V
105 Connected Tool ZERO Voltage V
106 Connected Tool Internal Gear Ratio (×100)
107 Connected Tool Serial No. (upper 3 digits)
108 Connected Tool Serial No. (lower 4 digits)
109 Connected Tool Rotation Direction
110 Connected Tool Order No. (upper 2 digits)
111
Connected Tool Order No. (lower 5 digits)
112 Connected Tool Cycle Count (×1 million)
113 Connected Tool Cycle Count (×1)
114 Connected Tool Maximum Current A
Unit
Information 2
200
Unit Setting Tool No.
○
201 Unit Setup
Tool Information “015M50”
202 Parameter Setting File Version
203 Sequence Setting File Version
204 PLC Output Layout Setting File Version
205 Fieldbus Setting File Version
206 Fieldbus Message Setting File Version
207 RS232C Input/Output Setting File Version
208 Unit RS232C-1 Communication Speed bps
209 Unit RS232C-1 Parity
210 Unit RS232C-1 Stop Bit bit
211 Unit RS232C-1 Word Length bit
Option
Information1
300 Connected Fieldbus Information
301 ANYBUS-CC Version
302 Unit Setting Fieldbus Information
303 Station No. (Node Address) (1 ~ 64 or 0 ~ 63)
304 Communication Speed (0 ~ 4)
305 Occupied Stations (1, 2, 3, 4)
306 Extended Cyclic Setting (1, 2, 4, 8)
307 I/O Setting
Byte Length “PLC
￫
MASTER
Spindle
”
308 I/O Setting
Byte Length “Master
Spindle
￫ PLC”
309 Message Block Byte Length
310 Message Setting
Byte Length “PLC
￫
MASTER Spindle
”
311
Message Setting
Byte Length “Master Spindle
￫
PLC”
312
IP Address (upper 6 digits)
313
IP Address (lower 6 digits)
314
Subnet Mask (upper 6 digits)
315
Subnet Mask (lower 6 digits)
316
Gateway (upper 6 digits)
317
Gateway (lower 6 digits)
(Continued on next page)
S0140185-H