DDK HFC3000II, Инструкция по эксплуатации

Страница: 176 / 216

Chapter 9 External Interface
PAGE 9-2
9-1. Common specifications
9-1-1. Fieldbus I/O signal specifications
(1)
Input signal specification
[PLC → HFC3000]
The input signal becomes the fixed layout.
Word Byte
Singnal Name Connection Contents
No. Bit# No. Bit#
IN
No.01
0
IN
No.01
0 Unused NO Always off.
1 1 Unused NO Always off.
2 2 Unused NO Always off.
3 3 Unused NO Always off.
4 4 BANK SELECT NO
Fieldbus message bank reshuffling BIT.
In the case of CC-Link the output top position of the
message Can change it.
5 5 Unused NO Always off.
6 6 RESET NO
Execute the following operation by setting this signal
to “ON”.
・
Stop tightening process.
・
Set the PLC I / O fastening result signal of the
controller to OFF.
・
Delete the entered ID data.
7 7
Unused Always off.(
～
V1.300)
ID SELECT
ENABLE
NO
WORK number selection by input ID becomes enable by
setting this signal to “ON”(V1.309
～
)
8
IN
No.02
0 Unused NO Always off.
9 1 Unused NO Always off.
10 2 Unused NO Always off.
11 3 Unused NO Always off.
12 4 Work Select Bit0 NO
Select the Parameter No.1~64 at Work Select 0~5.
13 5 Work Select Bit1 NO
14 6 Work Select Bit2 NO
15 7 Work Select Bit3 NO
IN
No.02
0
IN
No.03
0 STOP NO or NC
Emergency stop
1 1 RESET NO It has the same function as the above RESET signal.
2 2 REVERSE NO
Spindle will reverse(CCW) while active
3 3 START NO
Starts fastening cycle
4 4 PROGRAM NO
Bypass the unit
5 5
SELF CHECK
SKIP
NO
Skip self-check function
6 6 Unused NO Always off.
7 7
Unused
NO Always off.
8
IN
No.04
0 Unused NO Always off.
9 1 Unused NO Always off.
10 2 Unused NO Always off.
11 3 Work Select Bit5 NO Work Select 5.
12 4 BATCH OK RESET NO Initialize the number of cycle count to 0.
13 5 Work Select Bit4 NO Work Select 4.
14 6 Unused NO Always off.
15 7
Unused
NO Always off.
* Work Select Bits 0 to 5 are enabled with the system parameter: SYS.034 [00xxx1].
(Continued on next page)
S0140185-H