DDC POLYLASE LP, Руководство оператора

Страница: 29 / 55

- 11 -
Main Control Panel
Figure 3-7. Control Panel – Parameter Setting (Edit) Screen
Control Description
Parameter Setting Buttons Serve to display current device settings:
Beam Size (mm); Duration (pulse width, ms); Frequency
(Hz)-pulse repetition frequency. By pressing the
corresponding button the Parameter can be selected for
editing. Current value of each laser setting is displayed in
corresponding window.
Fluence Button Serves to set Fluence on the target. After user presets
desired fluence level, the system parameters are adjusted
based on the laser calibration table (stored in system
memory) and current Pulse Duration and Beam Size
settings. Fluence is a measure of energy density and is
shown as Joules/cm
2
Message / Prompt Area Place to display current system status, as well as Help and
Error messages. The numerical Edit Keypad is also
displayed in this area when there are no system messages.
Memory Selection Buttons Serve to recall pre-set Operating Parameters stored in each
of 5 Memory Buttons.
Save Button Serves to switch between EDIT and READY system modes
while saving new parameter settings.
Ready Button Serves to switch between EDIT and READY system modes
without saving new parameter settings.
Keypad Buttons Used to edit system operating parameters.
Pulse Counter Pulse Counter displays number of laser pulses fired since
last counter reset. In order to reset, press “
R “ button.
Service Button Used to switch between EDIT and SERVICE screens