DazeTechnology DazeBox C, Руководство по установке

Страница: 43 / 73

Follow Chapter 4.6 for the electrical connection, with the only caution being
to connect phase L1 of the three-phase system to the terminal marked L on
the DazeBox.
In the case of connecting several single-phase DazeBoxes to the same
three-phase system, we recommend "rotating the phases", i.e. if the first
DazeBox is connected to L1-N, the second is suggested to be connected to
L2-N and so on. This method ensures an even distribution of loads between
the phases in the system. Using this installation method and wanting to use
the DazeBox Power Management, however, some important precautions
must be taken into consideration:
▪
If more than one DazeBox is installed on the system, only one can
activate the Power Management function, any other DazeBoxes
installed downstream of the same meter must be configured to
have fixed power.
▪
If the phases are rotated, the current sensors of the Power
Management must also be connected to the same phase that
supplies the DazeBox. Example: If the L-N terminals of the
single-phase DazeBox are connected to L2 - N (phase 2 - neutral) of
a three-phase system, then the current sensor of the Power
Management must be connected to L2, after the electronic counter
and before each branch of the system.
For the installation of Power Management, see the dedicated manual.
4.10. Release coil connection
The release coil must be installed as described in Section 4.4.
43