3
PUMP OPERATION
The default state is Auto Mode in which the pump & heater are controlled automatically to
filter the water & maintain the desired water temperature. The Pump Button allows the user
to control the water pump manually as desired when using the pool.
Push 1 - Pump ON
(Heater automatic)
Push 2 - Pump OFF
(Heater OFF)
Push 3 - Auto Mode
(Pump & Heater automatic)
Note: If the user does not set the system back into Auto mode, the system reverts to
Auto Mode by itself, 90 minutes after the last push of the Pump Button.
Auto Light
The
YELLOW
or
BLUE
Auto indicator light will appear on the touch pad whenever the
system is in full automatic control mode. In this mode the system automatically activates
the pump & heater to filter the water & maintain the set water temperature. If this light is
flashing the water sensor is not detecting any water.
Pump Light
The
GREEN
Pump indicator light will appear on the touchpad whenever the pump is
running, in both auto & manual use mode.
Heater Light
The
RED
Heater indicator light will appear on the touchpad whenever the heater element
is on. For safety the heater is always automatically controlled. Usually switching on the
air blower accessory will cause the heater to switch off (loadshedding). This is in order to
keep the total power load to a safe level. If this light is flashing the system has an error.
(see back page)
Pump
