Daum electronic ego_bike Premium 8, Руководство пользователя

Страница: 30 / 44

!
Assembly and Installation Guide
30
2. Assembling instructions / dashboard support with the dashboard
Required hardware: Dashboard support (3) with the cable 1e
incl. the pre-installed dashboard, the U shaped handle
and the locking lever
Required tool: Wrench 13
2.1 When unpacking the unit, lay the dashboard support (3) with the mounted dashboard on a level and clean surface.
2.2 The dashboard cables (1e) protruding (sticking out) from the lower end of the support column (3) must be connected to
the device cable (in the receptacle of the support / ST) before the dashboard support (3) can be installed on the base frame
(1). The connectors (X & Y) must be plugged together. This operation cannot be performed by a single person. Given the
relatively important weight of the dashboard support column, a strong person should hold the support column (3) with the
dashboard cable (1e) sticking out close to the receptacle on the frame (ST). A second person plugs the connectors (X & Y)
together. Then they together install the dashboard support column (3) carefully on the receptacle (ST) of the frame. Take care
at this moment not to jam or separate the cables.
2.3
After the support column (3) is loosely installed, it must be oriented to align the holes to the threaded holes in the receptacle
(ST). Then screw in the three M8 screws (C) with the supplied spring washers (D) without tightening. We recommend tightening
the three screws (C) of the support only after all the parts have been installed (particularly the oscillating poles and the foot
rods) and adjusted. Then you can cover the heads of the screws with the supplied caps (J).
2.4
Then you can adjust the U shaped handle/grip (3b) and put it in the required position. The holding grip (U shaped) handle
is hold in position by tightening the locking lever (3a).
C
J
D
3
1
(1d)
(1e)
ST
2nd person
Connects the connectors x / y
of the dashboardand device
cables (1e / 1d)
2.4
1st person
raise and hold
Install the column on
the receptacle
2.3
U handlel /3b grip
M8
Locking lever
3a
X
Y
Warning! Avoid jamming or separating the
dashboard cable (1e / 1d) in the receptacle (ST).