3: Operation
RT7000-MSOP
3-9
(8) RECEIVE SET Rx ONLY
For making the displayed channel a receive-only chan-
nel by locking out the PTT. The status is automatically
set to
ON
whenever you press
ALPHA 8
.
ALPHA 18
(TX) reverses the receive-only state.
(9) SET CLOCK
Sets the internal clock (if installed) starting from the
year, down to the second. Enter the year, date, hour,
minute, and second pressing
E
after each value.
(10) ALARM TIMER
Automatically changes the status of the timer from
OFF
to
ON
whenever you press
ALPHA 10
. In the
ON
position, you can set the alarm using (
ALPHA 11
).
(11) SET ALARM
Sets a time for the sounding of the internal alarm. Enter
the year, date, hour, and minute pressing
E
after each
value.
(12) TIME AND DATE
Automatically displays the setting of the internal clock.
(13) TA/TS/SC Rx ADDR
For selection of a self ID. The current self ID is briefly
displayed. Use numbers from 000 to 255. This number
is usually the last three digits of a serial number.
(14) TRANSADAPT BER NUM
For setting the bit error rate (BER) to evaluate channel
performance. Higher number corresponds to the better
performing channel. Factory default is BER of 70.
(15) SCAN GROUP NUMBER
Allows selection of a scan group. This is the scan group
when using
ALPHA 2
and
ALPHA 3
. The default is
set to scan group 00.
Note:
Also use the
SCAN GROUP
icon on the front
panel to select a 7000TC scan group (provided
ALE
is
OFF
or not installed).
