1: Introduction
1-2
RT7000-MSOP
The RT7000-12 is powered from any DC source pro13.8V at a
maximum of 25A. Good performance is achieved when the input voltage is in
the range of 11 to 15.5V. The RT7000-28 is powered from any DC source
pro28 Vdc at a maximum of 15A (a range of 22 to 30 Vdc).
The RT7000 is used with broadband 50 ohm antennas or narrowband antennas
in conjunction with an automatic antenna tuner.
The RT7000 can be programmed and operated from its front panel or from an
external computer (if the ALE option is installed) utilizing a wide variety of
interface standards including RS232, 422 and 485.
Audio accessories available for use with the RT7000 include a heavy-duty
hand microphone, dynamic desk microphone, Morse key and headphones.
Technical Specifications
Note:
Specifications are subject to change without notice or obligation.
Characteristic
Specification
General
Frequency range
1.6 to 30 MHz (TX); 100 Hz to 30 MHz (RX);
10 Hz channel spacing
Preset channels
256 standard, 1000 optional
Scanning
Multiple scan groups, operator-selectable scan rates
Channel
programming
From front panel or remotely via computer or
dedicated remote control console
Frequency stability
0.5 ppm
Modes
USB, LSB, CW, AME; simplex or half-duplex
Input power
requirements
11 to 16 Vdc (+12 Vdc models);
20 to 32 Vdc (+28 Vdc models)
Input power
protection
Reverse polarity, transient and under/over-voltage
Antenna port
50 ohms, type N connector
Antennas
50 ohms or automatic antenna tuner (RAT7000B,
RAT1000C) for narrowband antennas
Interface
Control: two RS32 COM ports; compatible with EIA
RS422/423/485 with option.
Audio: 600 ohms, balanced and isolated
Mechanical, Environmental
Size (H x W x D)
6 in. x 14 in. x 18 in.
(15.2 cm x 35.6 cm x 45.7 cm)
Weight
35 lbs. (15.9 kg)
