3: Operation
3-20
RT7000-MSOP
Customizing TA/
TC/SC Scan
Group
Customizing a scan group involves reviewing the contents of a scan group,
adding and deleting channels from a scan group, and selecting the channels in
that group to scan.
1. Press
ALPHA 2
.
2. Press
E
.
Display:
SCAN SET CHANNEL x NNN
(where x is the channel status and NNN is the 3-digit
channel number)
Review channels in a scan group by pressing the arrow buttons to scroll
through them. Channels are displayed in numerical order. Change scan group
channels by deleting existing channels and adding new ones.
To delete existing channels from the group:
1. Use the arrow buttons to locate the channel to delete.
2. Using the alpha characters on the keypad, press
D
(delete).
3. Press
E
.
To add new channels to the group:
1. Use the up arrow to scroll past the highest numbered channel until
xxx
is
displayed.
2. Enter the number of the channel to add and press
E
.
3. Continue adding channels as necessary. Press
E
to exit this mode.
You can delete and enter a different single-digit channel by writing over the
contents of an existing channel. This is done by scrolling to the channel,
pressing the single-digit number of the channel to add, and pressing
E
.
To Start and
Stop Scanning
Press
SCAN
to start scanning within the selected scan group. Scanning begins
with the first channel in the selected scan group and continues in numerical
order as each channel number is displayed. Press
SCAN
again to stop the
scanning process.
