Datex-Ohmeda Anesthesia Delivery Unit S/5, Техническое справочное руководство

Страница: 46 / 494

Datex-Ohmeda ADU
4-10
Document No. 8502852
NOTE: The Anesthesia Monitor must be equipped with S-ARK95 or later software.
Configuring the software
Configuration requirements
The Anesthesia Delivery Unit is already factory configured in order to comply with national standards
and most common practices. The unit may be operated without changing these screen default
settings.
Datex-Ohmeda has designed the ADU so that the default settings may be changed to meet hospital
standards. Once changed and saved, the defaults will become active whenever the unit is turned on.
The factory defaults may always be reset if needed.
WARNING If the factory defaults values are reset, the flow bars order on the display will be
set-up to ISO standard.
If the factory defaults values are reset, the flow bars order on the display will be set to ISO standard,
i.e. that the flow bars order starting from the left side are O
2
- Air - N
2
O . This means that countries
using ANSI standard must change the flow bar order starting from the left side on the display to N
2
O -
Air - O
2
. This is done by entering the Install menu (distributor password level is required) - Fresh Gas
Setup and make necessary configuration changes. The colors of the bars will not be changed if the
factory defaults are reset.
NOTE: All the default changes should be performed first and then saved, all at the same time, by
using the Install menu. See “ Saving the Configuration” at the end of this section.
Always use the default configuration worksheet during a user default configuration and save a copy of
the sheet in the device history records.
System configuration
Check the following items and change configuration if required:
•
Ambient pressure on the Install - User config menu.
•
Primary driving gas for the Ventilator (O
2
or air) on the Install menu.
If the factory default settings are changed for these functions, they cannot be reset by the factory
defaults function. Resetting must be done manually.
Ventilator measurements Ppeak; Pplat; Peep; Pmin
Fresh gas settings Agent name; Agent % in fresh gas; Total flow
O
2
flow; N
2
O flow; Air flow
Events transferred during system check
System check test results Gas Delivery: Agent; Gas Delivery: N
2
O; Leak Tests: AUTO
AUTO leak [ml/min]; Leak Tests: MAN; MAN Leak [ml/min]
Number of confirmed checklist items; Bypass Check
Events transferred once a minute