Datex-Ohmeda Anesthesia Delivery Unit S/5, Техническое справочное руководство

Страница: 273 / 494

Calibration A-FGC1
Document No. 8502854
B-47
sd
Figure 45 Vaporizer temperature sensor calibration menu
2. Take out the Aladin Cassette and put the head of the temperature sensor side by side with the
temperature sensor of the vaporizer. (max. distance 1 cm) Let temperature value stabilize at
least 5 minutes. Do not hold the reference sensor with your hand, it may warm up and therefore
cause an erroneous calibration.
3. Compare the reference temperature and temperature of the sensor 1. If the difference is under
± 0.3
°
C, calibration is not needed. If the difference is more, the reference temperature must be
given: select Start CAL, Give Temp, change the correct temperature value and save the
calibration by selecting Save CAL .
NOTE: If the reference temperature is increased with more than 1°C the calibration will fail and the
calibration menu will be frozen. The only way to proceed is to turn ADU Off/On and make the
calibration again. If the reference temperature must be increased with greater than 1°C have this to
be done in severally calibrations. But before doing this check your measuring device and measuring
point.
4.
Select Previous menu . Perform the needed calibrations according to the Calibration Tree.