Datex-Ohmeda Anesthesia Delivery Unit S/5, Техническое справочное руководство

Страница: 457 / 494

Repair instructions A-ELEC
Document No. 8502856
D-27
6. Disconnect the gas supplies.
7. Slide the drive card cover back and tighten the two Pozidriv screws, which secure the cover.
8. Apply the self-adhesive label that is supplied with the kit onto the drive card cover.
Figure 28 Label location
9. Document the A-AUF ID and B-CPU4..01 serial numbers on the log sheet (last page in this
instruction).
10. Re-install the back cover and connect mains power.
11. Reconnect gas supplies and turn on the ADU.
12. Verify that the ADU screen appears normal and no errors are present.
13. Perform user configuration. Refer to the ADU TRM part I chapter 4 Installation instructions/
configuring the software.
NOTE: The PCMCIA card SW has factory default configuration loaded. This means the O
2
flow bar will
be on the left side of the N
2
O flow bar, also the gas colors may be different. To change the flow bar
location it is necessary to have the distributor password. To change the colors on flow bars it is
necessary to have the factory password.
14. Perform System Checkout (there are not needed to perform Functional Checkout after down
loading software).
Replacement of software cartridge in B-CPU2
Upon completion of this procedure:
•
It is not necessary to take out the A-ELEC from the ADU Frame
•
The country and user specific configurations must be reconfigured after installing a new Main
software cartridge (See section “Installation Instructions” and section 4 in the “User´s
Reference Manual” ).
1. Remove the EMC grid plate by unscrewing the three Pozidriv screws.