Dateq BCS25, Руководство пользователя

Страница: 6 / 28

6
Dateq BCS25 manual BCS25(E) dual line/ microphone input module
EN
BCS25(E) dual line/ microphone input module
The BCS25(E) input module is available with or without 3 band equaliser. The module can handle
up to 3 different signals: 2 stereo line and a mono microphone. Line input 1 and the microphone
input of this module are electronically balanced. Line input 2 is unbalanced but can be turned into
a balanced input by use of an extra pushon balanced line-input module. The microphone input is
equipped with phantom power which can be switched off.
Line 1/ Line 2 Input selector. When the switch is pushed (green LED is
lighted) line 2 is selected.
Mic Input selector. When the switch is pushed (green LED is
lighted) the microphone input is selected, regardless of the
inputselector for line 1 or line 2.
Overload The LED in the mic-switch lights up red when the signal
level anywhere in the module is too high and distortion can
occur (the limit is 6dB under cliplevel).
Gain Volume pre-setting. Range: -46dB to +12dB
High High-tone control (BCS25E only).
Shelving: ± 12dB @ 12kHz.
Mid Mid-tone control (BCS25E only).
Bell-curve: ± 12dB @ 1.3kHz.
Low Low-tone control (BCS25E only).
Shelving: ± 12dB @ 60Hz.
AUD/ PGM Bus-routing switches. When a switch is pushed (yellow LED
is lighted) the signal will be routed to the selected output.
AUX Volume control for AUX1-level. The AUX1-bus is pre-fader.
BAL Balance-control. The signal is placed at the desired position
in the stereo image.
CUE Pre-fader listening. The LED lights up green when the
CUE- function is activated. With an internal jumper the
master-cue function can be (dis-)activated.
ON On-off switch. It is possible to select faderstart, buttonstart
or a combination of both with an internal jumper. The yellow
LED is lighted when the channel is on.
Fader
100mm long volume control. Depending on a jumper-
setting the signal on the AUX2-bus is pre- or post-fader.