Dateq BCS25, Руководство пользователя

Страница: 8 / 28

8
Dateq BCS25 manual BCS25(E) dual line/ microphone input module
EN
Phantom power
Non-dynamically microphones usually need an external power supply for its built in pre-amplifier.
If this power has to be supplied by the BCS25, place jumper J1 in the ‘ON’ position. +48Vdc will
be supplied to both signal wires related to the cables shielding.
Jumper J1 is situated on the left side of the bussconnector. The factory default setting for this
jumper is ‘OFF’. See picture below:
Dynamically microphones don’t need a phantom power supply. When the correct cables are used
it will not damage the microphone when the phantom power supply is turned on. So it is not really
dangerous to turn the phantom power on for all types of microphones.
Faderstart/ buttonstart
The BCS25(E) module is able to remote start connected equipment by faderstart, buttonstart or a
combination of these two options. By changing jumpers you easily select one of these settings.
The jumpers for remote start settings can be found at the main PCB above the bussconnector
(jumper J8 and J9, see drawing).
Jumpers J8 and J9 select the type of operation. It is possible to choose between faderstart (figure
1), buttonstart (figure 2) or the fader-switch combinaton (figure 3).
Fig. 1
Fig. 3 Fig. 2