Dateq BCS25, Руководство пользователя

Страница: 11 / 28

EN
Dateq BCS25 manual BCS26(E) telephone input module
11
BCS26(E) telephone input module
The BCS26(E) telephone input module is available with or without 2 band equaliser. The module
is equipped with a built-in analogue telephone hybrid. Telephone lines can be directly connected
to this channel. Besides the built in hybrid an external hybrid or talk-show system can be
connected. In that case, the BCS26(E) channel operates as remote control only.
On/Off
Switches the (external) hybrid on or off. The green LED will
light up at an incoming ringer signal.
Overload The LED in the off-switch lights up red when the signal level
anywhere in the module is too high and distortion can occur
(the limit is 6dB under cliplevel).
Gain Volume pre-setting. Range: -15dB to +6dB
R-bal Compensation for the resistive part of the line-impedance.
High High-tone control (BCS26E only).
Shelving: ± 12dB @ 3.5kHz.
Low Low-tone control (BCS26E only).
Shelving: ± 12dB @ 600Hz.
AUD/ PGM Bus-routing switches. When a switch is pushed (yellow LED
is lighted) the signal will be routed to the selected output.
AUX Volume control for AUX1-level. The AUX1-bus is pre-fader.
BAL Balance-control. The signal is placed at the desired position
in the stereo image.
CUE Pre-fader listening. The LED lights up green when the CUE-
function is activated. With an internal jumper the master-cue
function can be (dis-)activated.
ON On-off switch. It is possible to select faderstart, buttonstart
or a combination of both with an internal jumper. The yellow
LED is lighted when the channel is on.
Fader 100mm long volume control. Depending on a jumper-setting
the signal on the AUX2-bus is pre,- or post-fader.