Datcon DT1102 (PS), Руководство по эксплуатации

Страница: 19 / 28

DT1102 (PS)
20220202-V0
19
5.7. Connecting instrument to the power supply
The following figure shows connecting the instrument to the power
supply:
Wiring plan, connecting
the power supply
(see also “Application
example”)
The polarity of the cables
is indifferent
1. Before connecting check that the supply voltage correspond with
the supply voltage written on the data label. When the instrument type
designation ends with „
PS
” then the power supply terminal coloured
black.
2. Connect only in the complete absence of line voltage
3. Loosen terminal screws.
4. Insert the wire ends into the open terminals according to the wiring
plan.
5. Screw the terminal in.
6. Check the hold of the wires in terminals by pulling on
them firmly.
Checking the
connections
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).