Datcon DT1102 (PS), Руководство по эксплуатации

Страница: 16 / 28

DT1102 (PS)
16
20220202-V0
5.4. Connecting voltage source to the input
The following figure shows connecting voltage source to the input:
Wiring plan, connecting
voltage source
(see also “Application
example”)
Be careful the polarity of
the cables
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Terminal (8) and (7) are out of use!
Checking the
connections
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).