USAGE
First of all, assemble IR SMARTLINK by
putting the IR adaptor and the VER-
SAPLUS cable together with the 15 pin
connector. Always tighten the locking
screws on the connector before use. Peel
off the protective covering on the free
end of the IR adaptor. Carefully center
the self-adhesive ring over the device‘s
infrared eye. Spare adhesive rings are
included with the smartlink.
Plug the snap-lock connector into one of
the four ports on the back of Dataton
SMARTPAX and set the SMARTPAX port
address to correspond to the device’s
address in TRAX. For more information
on programming applications using IR
SMARTLINK, refer to the TRAX hand-
book and device information database.
Technical Description
IR SMARTLINK connects SMARTPAX
to devices normally controlled by an
infrared remote unit.
Two cables form IR SMARTLINK: the
VERSAPLUS cable and the IR adaptor
(labeled 3453). The VERSAPLUS
cable has its own microprocessor
which is housed in the 15 pin D-sub
connector. The microprocessor trans-
forms the RS232 serial data that is
output by SMARTPAX into the pulse-
code modulated IR data used by the
device to be controlled.
The smartlink cable length is 1.6m
(63”) and may be extended with
Dataton EXTENSION CABLE article
number 3451 (1m), 3452 (2m) or
3455 (5m).
Squeeze
here to
disconnect
© Copyright 1997 by Dataton AB, Sweden. Specifications are subject to change without prior notice. Document reference no. 3700/48–49
Product sheets 970520 97-05-23 17.02 Page 49
