iboot-poe_v180808n
iBoot-PoE
Page 25
set autoconfig start
Starts auto config
get autoconfig
Displays the status: Running or
Found: No device, Single Ended, Multi Ended
User Commands
These commands are only available to the administrator.
set user account <yes | no>
This command sets whether or not a user account is used. If <n> only the
administrator account is active
n
set login required <yes | no>
This command sets whether or not a login is required for user level operation. A
login is always required for admin functions.
y
set password <user | admin> <old> <new> <repeat>
This command is used to set the password of either the user or administrator.
user
admin
Event Commands
These commands are only available to the administrator.
get events
This command displays all scheduled events as shown below. Example:
Date Time Repeats Action
1. 01/13/2013 16:00 every 1 Day(s) On Run
2. 01/13/2013 16:15 every 0 Day(s) On Run
3. 01/15/2013 17:00 every 1 Hour(s) Cycle Run
4. 02/16/2014 12:00 every 1 Day(s) Off Run
5. 02/16/2014 12:10 every 1 Day(s) On Run
6. 02/17/2013 01:05 every 0 Day(s) On Run
7. 02/18/2013 01:00 every 0 Day(s) On Run
8. 03/18/2014 01:00 every 0 Day(s) On Run
set time enable <yes | no>
This command enables or disables the use of the time server and scheduled
events.
Note:
When Adding new events through the CLI. Set this to no to prevent
unintended power switching
No
set time server <dotted decimal>
This command is used to set the IP Address of a network time server.
69.90.182.55
get time
Displays the current time and time server settings:
Current Time: 07/30/2015 10:41:05
Timezone: -5
DST: Enabled
Starts the 2nd Sunday of March at 2:00
Stops the 1st Sunday of November at 2:00
Server: time.nist.gov
set event <1-8> <run | hold>
This command is used to all the event to run, or put the event on hold
run
