iboot-poe_v180808n
iBoot-PoE
Page 24
set autoping <1 | 2> failcount <1-999>
This command is used to set the number of consecutive failures the AutoPings
must detect before the AutoPing considers the pinged device to be failed.
3
set autoping mode <single | and | or>
Sets single AutoPing or two AutoPing relationship And or Or.
Single
set autoping action <none | on-latch | on-follow | off-
latch | off-follow | cycle>
This command is used to set the action that the iBoot-PoE will perform when the
autoping triggers.
None
set autoping cycle <0-999>
This command sets the maximum number of power cycles when the AutoPing
triggers. 0 = Unlimited
1
set autoping wait <1-999>
This command sets the time, in seconds for the device to respond to a ping.
2
set autoping restart <1-999>
Sets the delay in seconds to restart AutoPing tests after Action. This command sets
the time, in seconds for the device to respond to a ping.
0
set traffic monitor <enable|disable>
Enable or disable the traffic monitor
Enabled
set traffic monitor failtime <1-999>
Fail time
10
set traffic monitor restarttime <0-999>
Restart time
10
set traffic monitor cycles <0-99>
Number of cycles
0
set traffic monitor min
<0-125000000> <kbps|mbps>
Min band width
0
set traffic monitor max
<0-125000000> <kbps|mbps>
Max band width
0
set traffic monitor maxtest <enable|disable>
Enable/disable maximum bandwidth test
Disabled
set traffic monitor startdisable <hh:mm>
Set the start disable time
<00:00>
set traffic monitor stopdisable <hh:mm>
Set the stop disable time
<00:00>
get traffic monitor
Traffic Monitor: Enabled or Disabled
Fail Time: in seconds
Restar Time: in seconds
Number of Cycles:
Minimum Bandwidth: as programmed
Maximum Test: enabled/disabled
Maximum Bandwidth: as programmed
Monitor Disable
Start Time: hh:mm
Stop Time: hh:mm
