Dataman 448PRO2AP, Руководство пользователя, Страница: 156 / 160

156
When PICmicro
®
device is programmed; pin MCLR\ / VPP is driven to approximately 12 V.
Therefore, the target system must be isolated from this voltage provided by programmer.
RB6 and RB7 signals are used by the PICmicro
®
for In-system programming; therefore target
system mustn’t affect these signals during In-system programming to avoid programming
errors.
Marginal verify is used after programming. Programmer must verify the program memory
contents at both minimal and maximal power supply, therefore VDD pin of PICmicro
®
must be
isolated from rest of target system during programming.
DATAMAN recommended circuit for PICmicro:
R1
R2
VSS
C1
22n
VSS
R7
47R
D1
VSS
VDD
VSS
R6 1k
D2
1N4148
VSS
R11
22k
C2
1u/25V
VDD
RB6
RB7
MCLR/VPP
VSS
I1
PICxxxxx
DATA
CLK
VDD
MCLR/VPP
ISP connector target device target system
reset circuit
VSS
*1
Note: External reset circuit is necessary only if VDD power-up slope is too slow.
Other
Please don't move Info window during BUSY LED is on - watching circuit can be activate to
switch the programmer in safe status as in case communication PC-programmer error.