Datalogic T4 Series, Быстрый старт

Страница: 8 / 22

T4x-SERIES QUICKSTART GUIDE
8
INDICATORS AND KEYPAD BUTTON
Figure 2 - Indicators
The following LED indicators are located on the camera (Figure 2):
1
POWER
On – camera is connected to power
2
NET
On – Ethernet link is established. Blinking - data transmission
3
ONLINE
On – Loaded tasks will be executed based on their trigger parameters
4
OUT
1 On – Output 1 is on
5
OUT
2 On – Output 2 is on
6
OUT
3 On – Output 3 is on
7
BUSY
LED blinks during image and flash memory access
8
BUTTON
Camera Reset: See Note below
To trigger the Camera Button event, press and release the button (Internal
software event trigger only)
Note: Camera Reset will restore the factory camera settings. This includes deleting all user settings on the camera
and resetting the camera’s IP Address and Mask to the factory default.
To Reset the Camera
1. Turn off power.
2. Press and hold the Camera Reset button.
3. Turn on power.
4. When all the LED indicators turn on and remain lit, release the Camera Reset button.
5. Wait approximately 30 seconds for the camera to restart.
1
2
3 4 5 6 7
8