Datalogic POWERSCAN 7000 2D Imager, Руководство по продукции

Страница: 65 / 204

Data Format Editor Introduction
Product Reference Guide 5-3
bols that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7.
Scan Save from the Programming Chart on page B-5 of this manual
to save your entries.
Other Programming Selections
Clear One Data Format — This deletes one data format for one sym-
bology. If you are clearing the primary format, scan 0 from the
Program-
ming Chart on page B-5
of this manual. If you are clearing an alternate
format, scan 1, 2, or 3, depending on the alternate format you are clear-
ing. Scan the Terminal Type and Code I.D. (see
Supported Terminals on
page 2-2
), and the bar code data length for the specific data format that
you want to delete. All other formats remain unaffected.
Save—
from the
Programming Chart on page B-5
of this manual. This
exits, saving any Data Format changes.
Discard—
from the
Programming Chart on page B-5
of this manual. This
exits without saving any Data Format changes.
Data Format Editor Commands
Send Commands
F1 Send all characters followed by “xx” key or function code, starting from
current cursor position. Syntax = F1xx (xx stands for the hex value for
an ASCII code, see ASCII Conversion Chart (Code Page 1252) on
page A-4 .)
F2 Send “nn” characters followed by “xx” key or function code, starting from
current cursor position. Syntax = F2nnxx (nn stands for the numeric
value (00-99) for the number of characters and xx stands for the hex
value for an ASCII code. See
ASCII Conversion Chart (Code Page 1252)
on page A-4 .)
F3 Send up to but not including “ss” character (Search and Send) starting
from current cursor position, leaving cursor pointing to “ss” character fol-
lowed by “xx” key or function code.
Syntax = F3ssxx (ss and xx both
stand for the hex values for ASCII codes, see ASCII Conversion Chart
(Code Page 1252) on page A-4 .)
F4 Send “xx” character “nn” times (Insert) leaving cursor in current cursor
position. Syntax = F4xxnn (xx stands for the hex value for an ASCII
code, see ASCII Conversion Chart (Code Page 1252) on page A-4 , and
nn is the numeric value (00-99) for the number of times it should be sent.)
E9 Send all but the last “nn” characters, starting from the current cursor posi-
tion. Syntax = E9nn (nn is the numeric value (00-99) for the number of
characters that will not be sent at the end of the message.)