Datalogic Gryphon I GPS4400, Руководство по продукции

Страница: 263 / 316

Data Editing References
Product Reference Guide 253
It is possible to define the Match string by inserting any printable characters
or non-printable ASCII characters available in the list inside the parameter
edit box
No wild card characters are supported.
To set this feature:
1. Determine the desired character string (max 32).
2. Reference the ASCII Chart on the inside back cover of this manual to
find the hex value assigned to the desired character.
3. Go to "
Match String" on page 57
and scan ENTER/EXIT PROGRAMMING
MODE to enter Programming Mode.
4. Scan the barcode: SELECT MATCH STRING.
5. Turn to
Appendix D, Keypad
and scan the barcodes representing the hex
characters determined in step 1 above.
6. If less than the expected string of 32 characters are selected, scan the
ENTER/EXIT barcode to terminate the string.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to complete.
Wrong Code String
The string sent in case of a mismatch (wrong code read). To set this feature:
1. Determine the desired character string (max 20).
2. Reference the ASCII Chart on the inside back cover of this manual to
find the hex value assigned to the desired character.
3. Go to "
Wrong Code String" on page 57
and scan ENTER/EXIT PROGRAM-
MING MODE to enter Programming Mode.
4. Scan the barcode: SELECT WRONG CODE STRING.
5. Turn to
Appendix D, Keypad
and scan the barcodes representing the hex
characters determined in step 1 above.
6. If less than the expected string of 20 characters are selected, scan the
ENTER/EXIT barcode to terminate the string.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to complete.
Label Transmit Mode
Specifies whether the decoded label must be transmitted over the host
interface as it has been decoded or after the reading phase has been deacti-
vated (phase off). This does not apply to Test Mode.