Datalogic Gryphon I GPS4400, Руководство по продукции

Страница: 24 / 316

You must first enable your reader to read bar codes in order to use
this section. If you have not done this, go to
Setup, starting on
page 5 and complete the appropriate procedure.
Enter/Exit Programming Mode Configuration Using Bar Codes
14 Gryphon™ GPS4400
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of
each programming page, when applicable.
2. Scan the bar code to set the desired programming feature. You may
need to cover unused bar codes on the page, and possibly the facing
page, to ensure that the reader reads only the bar code you intend to
scan.
3. If additional input parameters are needed, go to
Appendix D, Keypad
, and
scan the appropriate characters from the keypad.
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT
PROGRAMMING bar code to exit Programming Mode.
For more detailed descriptions, programming information and examples for
setting selected configuration items, see
References, starting on page 231
.