Datakom DKG-255, Руководство пользователя

Страница: 18 / 26

DKG-255 User Manual Firmware V-1.0
- 18 -
Parameter Definition Unit Min Max
Factory
Set
Description
P_01 Nominal Speed rpm 1000 2000 1500
This parameter defines the nominal
(target) speed of the engine.
P_02 Idle Speed rpm 500 1500 900
This parameter defines the idle speed
of the engine when idle input is active.
P_03 Delayed
Overspeed Limit
% 105 200 110
If the engine rpm goes over this limit
during overspeed delay timer (P_05),
this will generate an overspeed alarm.
P_04 Immediate
Overspeed Limit
% 110 200 120
If the engine rpm goes over this limit,
this will generate an overspeed alarm.
P_05 Overspeed Delay
Timer
sec 1 10 5
If the engine rpm goes over P_03
during this timer, this will generate an
overspeed alarm.
P_06 Cranking rpm rpm 0 300 10
During engine cranking, if the rpm is
above this limit, the unit activates the
actuator output. (P_09)
P_07 Running rpm rpm 300 1000 400
This parameter is the limit to start speed
ramping with PID control.
P_08 Crank Teeth Count - 2 500 100
This parameter defines the flywheel
teeth number of engine. If alternator
voltage is used for speed sensing, this
paramet
er should be set to “
2
”.
P_09 Starting RPM Fuel % 5 100 45
This parameter defines the amount of
actuator output during cranking.
P_10 Running RPM Fuel % 0 100 50
This parameter defines the amount of
actuator output when the engine has
fired. It is calculated as a percentage of
parameter P_09.
P_11 Speed Ramping
rpm Rpm /
sec
10 9999 200
This parameter defines the value of the
speed ramping in rpm/sec.
P_12 Low Battery
Voltage
Vdc 2 30 8
This parameter defines the low battery
voltage alarm limit.
P_13 Global Gain - 1 9000 20
This parameter governs the nominal
rpm catching of the controller.
If this parameter is increased, the
operation will be faster but unstable. If it
is decreased, the operation will be
slower but more stable. The optimal
setting is the fastest stable operation.
P_14 P Gain - 0 9999 100 Proportional gain.
P_15 I Gain - 0 9999 50 Integral gain.
P_16 D Gain - 0 9999 40 Derivative gain.
P_17 Aux Enable - 0 1 0
0: Aux input disabled
1: Aux input enabled
P_18 Aux Speed rpm 10 300 300
This parameter defines the value of
speed change when aux is enabled.
P_19 Droop Gain % / A 0.1 10 4
This is the parameter to adjust the
amount of droop.
P_20 Trim Enable - 0 1 0
This is the parameter to enable speed
control with external potentiometer.
0: External speed trim disabled
1: External speed trim enabled
P_21 Trim Gain % 5 20 10
This is the percentage of running rpm to
adjust the engine speed with external
potentiometer.
7. PROGRAM PARAMETER LIST