Connecting Hosts
E F 3 0 1 5 S e t u p G u i d e ( R e v A )
25
a) At the login prompt, enter the default user
manage
.
b) Enter the default password
!manage
.
If the default user or password — or both — have been changed for security reasons,
enter the secure login code instead of the defaults shown above.
6.
At the prompt, enter the following command to set the values you obtained in Step
for each Network port, first for controller A, and then for controller B:
set network-parameters ip address netmask netmask gateway gateway
controller a|b
where:
-
address
is the IP address of the controller
-
netmask
is the subnet mask
-
gateway
is the IP address of the subnet router
-
a|b
specifies the controller whose network parameters you are setting
For example:
# set network-parameters ip 192.168.0.10 netmask 255.255.255.0
gateway 192.168.0.1 controller a
# set network-parameters ip 192.168.0.11 netmask 255.255.255.0
gateway 193.168.0.1 controller b
7.
Type the following command to verify the new IP addresses:
show network-parameters
Network parameters, including the IP address, subnet mask, and gateway address are
displayed for each controller.
8.
Use the
ping
command to verify network connectivity.
For example:
# ping 192.168.0.10 (gateway)
Info: Pinging 192.168.0.10 with 4 packets.
Success: Command completed successfully. - The remote computer
responded with 4 packets
.
9.
In the host computer's command window, type the following command to verify
connectivity, first for controller A and then for controller B:
ping controller-IP-address
If you cannot access your system for at least three minutes
after changing the
IP address
, you might have to restart the Management Controller(s) using the serial
CLI.
When you restart a Management Controller, communication with it is temporarily lost
until it successfully restarts.
Type the following command to restart the Management Controller in both controllers:
restart mc both
10.
When you are done using the CLI, exit the emulator.
