Datacolor Conditioner Operation Manual / DCCOPMN_RP1 / Rev 3.0 / 7th August 07
page 44 of 51
11.3 Cleaning and decontamination
DANGER
Electrical hazard.
Danger of life.
∅
Do NOT spill water or cleaning agents over the inner and outer surfaces.
¾
Put off-circuit the unit before cleaning. Pull the power plug.
¾
Completely dry the appliance before switching it on again.
11.3.1 Cleaning
•
Disconnect the chamber from the mains before cleaning. Pull the power plug!
•
Wipe the surfaces with a moistened towel. In addition, you can use the following cleaning agents:
Exterior surfaces, inner
chamber, racks, door
gaskets
Standard commercial cleaning detergents free from acid or halogenides.
Alcoholic solutions.
Instrument panel
Standard commercial cleaning detergents free from acid or halogenides.
For surface protection, perform cleaning as fast as possible.
After cleaning completely remove cleaning agents from the surfaces with a moistened towel.
11.3.2 Decontamination
•
Disconnect the chamber from the mains prior to decontamination. Pull the power plug.
•
You can use the following disinfectants:
Inner chamber
Standard commercial surface disinfectants free from acid or halogenides.
Alcoholic solutions.
In case of impurity of the interior with biological or chemical hazardous goods, there are two possible
procedures depending on the type of contamination and of the charging material.
1. Spray the inner chamber with an appropriate disinfectant.
Before start-up, the unit must be absolute dry and ventilated, because explosive gases might form
during the decontamination process.
2. If necessary, have strongly contaminated inner chamber parts removed by an engineer for cleaning,
or have them exchanged. Sterilize the inner chamber parts in a sterilizer or autoclave.
With every decontamination method, ensure adequate personal safety.
CAUTION
Danger of corrosion.
Damage of the unit.
Do NOT use acidic or chlorine cleaning detergents.
