Datacolor Conditioner Operation Manual / DCCOPMN_RP1 / Rev 3.0 / 7th August 07
page 29 of 51
6.
Setting up the controller RP1
•
Press to move from the basic display to the menu for selecting and changing the operating
parameters (Table 3 on page 30 or Table 4 on page 31).
The controller's lower display always shows the parameter type (e.g. SP) and the upper display shows
the value associated with that value (e.g. 15.0) (see Figure 6).
If the value in the upper display is a temperature in °C or a humidity in %RH, the corresponding yellow
LED to the right of the display will light up.
Figure 6: Displaying the parameter for the temperature set point,
lower display: Parameter type, upper display: Value (e.g. in °C)
•
Press
button to move to the next parameter.
Pressing the button
will confirm the change made to the value of the current parameter and the
unit will control towards the new set point.
To not confirm the changed value wait 30 seconds without pressing any button. The controller will
then automatically move back to the basic display without accepting the changed value (see Figure 5).
•
To change the values of the parameters press buttons
or
if the buttons are not locked (chapter
Numerical values can be changed by tenths by pressing
and
for a very short time, and
changed by whole numbers by pressing them for longer.
•
Press
button repeatedly to go back to the basic display (see Figure 5).
The controller is automatically set back to the basic display if no buttons are pressed within 30
seconds after a parameter is accessed or a value is changed.
If the value of the currently displayed parameter has been changed and the button
has not
been pressed, the change of the parameter’s value is lost by jumping back to the basic
display.
