2
Installation
Ethernet Requirements
You
can
connect
many
network
printers
to
one
PC.
The
maximum
number
of
printers
depends
on
the
capacity
of
the
network
to
deliver
data
to
the
printer.
To
install
an
SD260
printer
on
a
network,
the
following
components
are
required:
An
Ethernet
network
that
uses
the
TCP/IP
protocol
and
can
run
at
100
megabits
per
second,
also
called
100base
‐
T.
Printers
also
support
10base
‐
T.
An
Ethernet
cable
to
connect
the
printer
to
the
network.
An
Ethernet
cable
is
not
supplied
with
the
printer.
A
PC
that
meets
the
“PC
Requirements”
described
on
page 1
,
and
is
connected
to
and
communicating
with
the
network.
USB Requirements
You
can
connect
up
to
eight
card
printers
to
a
PC
using
USB
cables.
To
install
a
printer
using
a
USB
connection,
the
following
components
are
required:
A
high
‐
speed
USB
port.
USB
2.0
is
required.
A
USB
2.0
cable
to
connect
the
printer
to
the
PC.
A
USB
cable
is
supplied
with
the
printer.
A
PC
that
meets
the
“PC
Requirements”
described
on
page 1
.
If
you
need
to
connect
two
card
printers
to
a
PC
with
one
USB
port,
use
a
single,
independently
powered
USB
hub
to
which
you
can
connect
both
printers.
Electrical Requirements
The
power
supply
detects
the
input
voltage
and
works
within
the
range
stated.
Printer
Model
Electrical
Requirements
Input
Output
SD160
or
SD260
110–240V/50–60
Hz/1.5
Amp
24V/3.0Amp/72W
Содержание SD160
Страница 4: ...iv ...
Страница 10: ...x ...
Страница 28: ...14 Installation ...
Страница 78: ...64 Printer Manager ...
