DataCard SD160, Инструкция по установке и руководство администратора

Страница: 18 / 90

4 Installation
Set Up the Printer
This section provides information about setting up the printer to print cards.
Setup includes the following:

Prepare the Printer

Install Optional Equipment on page 8

Install the Card Printer Driver on page 13
Prepare the Printer
To prepare the printer to print cards, load blank card stock into the input hopper, and load print
ribbon and a cleaning sleeve onto the print cartridge. If you are printing rewritable cards, refer to
“Prepare the Printer to Use Rewritable Cards” on page 7 .
Load Cards
If you are using a manual feed printer or are printing rewritable cards, skip this step and keep a
supply of blank cards close to the printer.
Do the following to load the input hopper:
1.
Open the input hopper.
2.
Load the cards into the input hopper.
Cards can stick together. Slide or fan the
cards to separate the edges before placing
them in the hopper. Handle cards by their
edges only. Refer to “Card Handling” on
page 71 for more information.

Insert ISO magnetic stripe cards with
the stripe (back side) facing down and
toward the right.

Insert smart cards with the smart card chip facing up and toward the back of the hopper.
3.
Close the input hopper.
A diagram inside the hopper shows the correct orientation for each type of card.