DataCard SD160, Инструкция по установке и руководство администратора

Страница: 64 / 90

50 Printer Manager

YMCPowerNosRGB —Modify the intensity when you are printing without the sRGB color
mode.

Increase the value to make the non ‐ sRGB color darker

Decrease the value if using non ‐ sRGB color mode to prevent overly dark printing or
ribbon wrinkles or tears.

YMCWhiteShade —Modify the amount of power applied to the printhead to reduce ribbon
friction without transferring material. Decrease the value if unprinted or white areas of the
card have color applied to them and should not.
Pick
The Pick settings define how cards are picked from the input hopper. Pick settings are available
for WebService access ‐ level users only. Contact your service provider for information about
changing the printer’s pick settings.
Transport
The Transport options allow you to set values for card travel through the printer.
Change the settings as needed, and then click Set Current to apply the changes.

EjectHopperSpeed —Optimize the card eject speed based on the hopper type.

Select Standard if the printer has a standard output hopper.

Select Extended if the printer has an extended (100 ‐ card) output hopper.

TransMedSpeed —The speed at which the transport motor runs when clearing errors. You
cannot change this value.
Flipper
The Flipper settings define values for the duplex module in duplex ‐ option printers. Flipper
settings are available for WebService access ‐ level users only.
Description Default Value Current Value (unit) Allowed Range
1) EjectHopperSpeed Standard Standard
2) TransMedSpeed 800 1500 StepsPerSecond [300 – 1800]
If you have installed the 100 ‐ card output hopper, change the EjectHopperSpeed
setting to Extended to allow completed cards to stack properly in the hopper.